Hello,
I am using an ISC 1781 Smart Camera with Vision Builder 2015 software installed with the starter kit I/O board. This is a brand new setup.
I created a recipe in vision builder 2015, but when I get to the "Generate Pulse" step, I am not receiving any outputs at my board, and therefore not to my output device. No matter how what settings I use for the generate pulse step (drive high/low, generate single pulse/ start pulse generation, pulse on completeion of X/ generate pulse when setp runs), I cannot receive an output to the board.
We have tested the ISO outputs 0, 1, and 2 with a voltage meter, but do not receive a signal from the camera.
I have used the NI 1772 cameras with a similar setup, and had no issues. However, this model was discontinued, and we had to upgrade to the ISC 1781, but cannot get it working.
Any ideas?