Hello,
I have only been working with DAQ and LabView for 3 weeks as a school project.
I have a Gems-FT 110 flow rate sensor, and attached is the spec sheet that comes with the sensor. From the spec sheet, the sensor is giving out readings in frequency. My receiver is NI USB DAQ 6001, and in order to pick up frequency I have to set my daq assistant as digital input. The wiring connection I currently have for the flow rate sensor is positive goes to the 5V port of the digital side of the daq 6001. Negative wire of the flow rate sensor goes to the Ground port of the digital of the daq 6001. And the signal wire goes to the PFI 0 (which is the port 2 of digital input). However, I do not have any readings at all. Please correct me or give me some guidance over this.
Thanks,
Anh T.