Has anybody been able to read a sensor that communicates through SDI12 protocols? Any leads would be very useful.
This is what I have:
Sensor: ATMOS 14 from Meter.com. The sensor specifies compatibility with any data acquisition system capable of 3.6- to 15.0-VDC power and serial or SDI12 communication.
Data acquisition: NI USB-6008 (it is unclear to me if this datalogger works, it does have digital I/O channels so it seems it should work)
I tried connecting it to NIMAX following the steps below:
Connecting Digital Input Signals to a DAQ Device - National Instruments (ni.com)
But I basically only see the image below regardless of what is connected where in the datalogger
I tried running the program "Digital continuous input.vi" from the examples provided in LABVIEW2018, and it just gives me an error.
I know many sensors communicate through SDI12 protocols so I am hoping someone did something similar before?
The integrator guide of my sensor provides commands to interact with the sensor, for example ai! for identification, etc.
Thank you!