Hi,
I am trying to drive an optocoupler (Siemens SFH615A - spec link attached) using the USB-6501. I am very much a beginner and I'm looking for
help on how I can connect this. I have tried a few options already but no luck.
http://docs-europe.electrocomponents.com/webdocs/009c/0900766b8009c194.pdf
I am using a Servo drive in a project, driving a motor. Unfortuantely as the USB-6501 turns all lines logic High on start up the servo drive is
receiving a signal. I am hoping that I can pass the INHIBIT line of the servo drive through the optocoupler, so during start up the 6501 will cause the optocoupler
circuit to close and ground the inhibit line preventing the motor from moving. The labview program will make the line logic low to allow the motor to move.
From looking at the USB-6501 manual and previous questions there are 2 ways of doing this, but working out the resistor values etc needed is
still a little beyond me and unfortunately I'm a little stuck for time.
Any help would be greatly appreciated, thank you.