Hello,
I am new to Labview and to Digital output module in general.
I would like to use an NI 9476 to actuate 24 V relays. My setup consists of a 24 V power supply feeding into the Vsup and COM channels and I have multiple relays connected to the terminal blocks and would like to pass control signals (continuous signal when on) to them.
I tried to use DAQ assitant passing the signal to the desired output, but I am getting the following error.
Non-buffered hardware-timed operations are not supported for this device and Channel Type. Error - 201025.
I read through knowledge base and reveiw the forum search results, but was not able to understand.
Can I still use DAQ assitant to control outputs on 9476 or do I need to write new codes for this?
It would be greatly appreciated if you could give me some guides to work on this. (Like simple VI to start with).
Thank you.
Jake