Hello, I just started this time-sensitive project last week (and began using LabVIEW at the same time) and I am looking for help to control two solenoid valves using an NI 9482 relay and a cDAQ-9172. I would like to run my program for a set (variable) amount of time (probably about 3 sec). Half a second after starting, I would like my first solenoid valve to open, and then a certain amount of time after that I want my second valve to open. I would like them to remain open until the program has run for the set amount of time, then I want them to close at the same time at the end of the program's run time. I am looking for advice on the simplest way to perform this using LabVIEW. Thank you.
↧