USB-6501 DIGITAL OUTPUT

Hello all,   I have a brand new NI USB-6501, and I'm looking for some help with operation. I want to use 6501 as a 8:1 multiplexer controller.  This table below are the signals that I want to generate. 

Step     P0.0     P0.1     P0.2     P0.3

  1           0           0           0           1

  2           0           0           1           1

  3           0           1           0           1

  4           0           1           1           1

  5           1           0           0           1

  6           1           0           1           1

So there are 6 steps, 4 lines generate signal at the same time. I want to set the step time as 10 second. I am just not too familiar with LabView.  Please help!