Hi,
I don't have much technical knowledge about I2C, SPI or Labview but I have some basic questions.
I have a program that was using the USB-8451 to extract information using a few of the pins.
It turns out USB-8451 was no longer sold so I got the USB-8452. With the change, there are no more terminal blocks on both side, only pins, as shown below:
https://www.ni.com/docs/en-US/bundle/ni-845x-hw-dsw-getting-started/resource/371746e.pdf
I don't have much knowledge on these kinds of topics.
Would I be able to use the same program and just use the I2C_SDA, I2C_SCL, and +5V pins?
Or would I need to have someone change the program?
What needs to be done?
Any help would be appreciated. Thank you!!