Hello,
In LV 2010 version, I'm trying to just gow an LED using 9401 I/O module. I'm using Mod2/DIO1 to connect a switch and Mod2/DIO0 to connect to an LED. The switch is used as a control and LED as an indicator. Mod2/DIO1 is set to write and Mod2/DIO2 is set to read. I compiled the program successfully and ran it but the LED did not glow both in the Front Panel as well as the Block Diagram. What could possibly the problem?
Also I attached the .vi file I made. Please check the file and make corrections if any.
Thanks!