Hello, I'm new to labVIEW and using DAQ cards. I've been trying to run the "test panels" program to successfully get my card to output a 5V signal on any of the lines in port 0 or 1. When I set port 0 to output and select "all high" I would expect a multimeter to give me 5V when I measure any line, from 0-7, compared to the ground but this is not the case. I've just been getting <20 mV noise. I also tried to run the "self-test" which just says it completes successfully with no extra information. What else should I be doing to get a 5V output? Is there something I'm missing?
I am eventually going to use the card to operate 11 valves with each line turning an individual valve on or off.
