Dear all,
I am quite new with Labview and I have recently received a SB rio board 9606 +.
I followed the guidelines with respect to its setup but when I turned on the board, after some seconds, the led number still blicks twice per cycle.
I checked on the manual and i got :
"The device has detected an error in its software. This usually occurs when an attempt to upgrade the software is interrupted. Reinstall software on the device. Refer to the
Measurement & Automation Explorer Help for information about installing software on the device."
Besides I find it very strange for something brand new, i could find anything there which guides me to solve my problem. How do i reinstall the software on the device?
Thank you for attention.
Regards,
Pedro Santos