NI 9205 voltage reading error

Hi all,

I have a 9205 analog input module, and in the past was able to read two single-ended analog inputs around 2.7-2.8 V correctly, on a Ethernet RIO 9148.
However recently the module has stopped reading the correct voltages, and I am puzzled as to why this is.
I can confirm that the voltages measured at the terminals are around 2.7 V (between the AI pins and COM) with the module plugged in, but in the NI Distributed System Manager the values are showing up as around 6.7-7.0 V.

In terms of configuration:
In the LabVIEW project, all the pins are configured for Referenced Single-Ended (RSE) Measurements, in the +/- 10 V range.

Is there any way the module itself is functioning incorrectly/faulty? Nothing I can think of has changed hardware side, and as I mentioned, in the past I could read these voltages correctly.

Regards