what modules to be used

Hi .. i would like to connect the following sensors to a Ni DAQ system: 

1. pressure sensor 

• Honeywell - HSCMRRN016MDAA5-ND
https://www.digikey.com/product-detail/en/honeywell-sensing-and-productivity-solutions/HSCMRRN016MDAA5/HSCMRRN016MDAA5-ND/4949299

2. hotwire sensor

• Dantec Dynamics
https://www.dantecdynamics.com/miniature-wire-probe-straight

3. force sensor

Forsentek - 3 force comp (30 N capacity) - http://forcesensor.en.hisupplier.com/product-2658821-3-axis-load-cell-three-dimensional-force-sensor.html

i would like to know which voltage input modules should be used and which model of Ni DAQ chasis to be used ? 

will those will be ok ? i want to make sure if those will work and if a certain module can make all this sensors work? 

Chassis 4 slot NI cDAQ-9174 chassis
http://www.ni.com/en-lb/shop/select/compactdaq-chassis?modelId=125698

pitot tube module (connected to pressure sensor) NI 9215
http://www.ni.com/en-lb/shop/select/c-series-voltage-input-module?modelId=122167

Force Balance Module NI 9201
http://www.ni.com/en-lb/shop/select/c-series-voltage-input-module?modelId=122155

Temp sensor and hotwire NI 9219
http://www.ni.com/en-lb/shop/select/c-series-universal-analog-input-module?modelId=122171

thanks in advance